Paoli SUPERSPORT DP 3000 Manual De Instrucciones página 5

OPERATING AND MAINTENANCE MANUAL
GENERAL INSTRUCTIONS
L Wheel gun intended to be used for
professional use by trained personnel and
equipped with appropriate technical skills.
L Do not operate the wheel gun without the
prescribed safety devices.
L The drive shaft of the wheel gun and the
socket fixed to it may continue to rotate for
a short time after the release of the trigger.
L Verify that the WARNING label
Fig.1-W) is present and legible, otherwise
replace it by applying new one in the original
position.
OPERATING INSTRUCTIONS
L Always use a wheel gun with the tightening
torque corresponding to the one required
by the application.
L Please pay attention to your wheel gun version:
⚪ the Fast Left Hand (LH) version loosens
nuts tightened clockwise faster;
⚪ the Fast Right Hand (RH) version loosens
nuts tightened anticlockwise faster;
⚪ the Unhanded (UH) version loosens at
same speed both the nuts tightened
clockwise and anticlockwise.
L In order not to compromise the functionality
of the rotation reverse shaft, do not unscrew
or loosen never the rotation reverser grub
screw (view figure
Original operating instructions
Clutch Cover
Motor Cover
(view figure
Fig.2-C).
- The original language of these instructions is English.
TAB. A
L Do not use the wheel gun with the screws of
the clutch cover (view figure
motor cover (view figure
tight enough (see table Tab. A "Tightening
Torques"). If not tighten them with a torque
wrench following the tightening sequence
shown (view figures Fig.2-E and
L Pay attention to the exhaust coming out
by the wheel gun during operation
figure Fig.2-B). To avoid compromise the
performance of the wheel gun, not obstructed
in any case these holes of exhaust.
L The standard adjustment of the force
necessary for the translation of the
rotation reverse shaft, and thus the
reverse is already performed by Dino
Paoli s.r.l.. A personalized set of this force
is not possible (view figure
L The modes for the correct grip intended
for use of the wheel gun is as follows
figure Fig.2-D):
⚪ right hand grip on the gun body;
⚪ left hand grip on the surface of the hammer
case.
TIGHTENING TORQUES
M6 Screw
M5 Screw
Fig.1-E) or the
Fig.1-P) loose or not
Fig.2-F).
(view
Fig.2-C).
(view
22 Nm
12 Nm
ENGLISH
5