OPERATION
beeping.
Touch OK acknowledge the completed pro-
gramme.
Open the door ajar to the first position (about
15°).
You can open the door all the way after a few
seconds.
Then place deep baking tray under the water
drain.
Press OK to drain the remaining water from
steam system.
Wipe oven cavity dry with a cloth.
When you have run steam programmes
several times, start the oven fan heater for 30
minutes at 180°C.
NOTE: Danger of burns! Hot steam may es-
cape when you open the oven door. Be careful
when you open the oven door during or after
cooking. Do NOT lean over the door when
you open it. Please note that depending on
the temperature the steam can be invisible.
IMPORTANT: Ensure there is no water in
the steam system when you use standard
heating functions. Do not add water into the
container drawer when using the standard
heating functions.
54
Descale the steam system
When you have run several steam pro-
grammes, a flashing P10S message will be
shown on the display. This message prompts
you to descale the system. Select P10S from
the list of pre-set programmes to descale the
appliance. You can skip descaling twice, by
touching the
sensor. However, eventu-
ally the appliance will not allow you to run a
steam programmes again until you descale
the appliance.
Descale the appliance.
•
Prepare the solution of 450 ml of water
and 50 ml of liquid descaling agent.
•
Pour the solution into the water contain-
er drawer.
•
Press OK to start the P10S programme.
NOTE: During the descaling programme,
you will need to drain water from the steam
system 3 times.
Drain the descaling solution from the system
when you hear a beep and steam indicator
is flashing.
•
Open the oven door.
•
Then place deep baking tray under the
water drain.
•
Press OK to drain the remaining des-
caling solution from the steam system.
Pour the solution out of the baking tray
and rinse it with water.
To rinse the steam system, pour 0.5 l of clean
water into the water container drawer and
touch OK to continue the steam programme.
Drain the descaling solution from the system
when you hear a beep and steam indicator
is flashing.
•
Open the oven door.
•
Then place deep baking tray under the
water drain.
•
Press OK to drain the remaining des-
caling solution from the steam system.