Zooming - Sony RM-IP10 Manual De Instrucciones

CAMERA Maximum panning/tilting speed
button
BRC-Z700,
BRC-H900
5 29 degrees/sec.
6 43 degrees/sec.
7 60 degrees/sec.
Only the CAMERA button you pressed flashes, and
the corresponding maximum panning/tilting speed
is set.
Note
The maximum panning/tilting speed setting is stored in
the memory of the IP remote controller RM-IP10. If you
use another IP remote controller RM-IP10 or you
connect another camera to the RM-IP10, set a limit on
the maximum panning/tilting speed again.
To face the camera back to the front
Press the button on the top of the joystick for one or two
seconds.
Press for 1 or 2 seconds.
If you accidentally move the camera with
your hand
Press the PAN-TILT RESET button to perform the pan/
tilt reset action.
If the camera moves in a different
direction from that you intended
The camera is preset to face toward the right whenever
the joystick is inclined to the right. You might wish to
face the camera toward the opposite direction from that
in which you inclined the joystick, for example, when
you change the direction of the camera while checking
the picture on the screen. In such a case, set DIP 2 switch
2 to ON.
To reset the setting, set DIP 2 switch 2 to OFF.
Joystick
BRC-Z330
Incline to the right.
29.2 degrees/sec.
43.4 degrees/sec.
60 degrees/sec.
The setting above only changes the signal emitted from
the IP remote controller RM-IP10, and does not change
the setting of the camera itself.
If the STANDBY lamp of the camera
flashes
When the camera is moved or turned by hand or by
external shock, the microcomputer inside the camera
may not be able to memorize the pan/tilt position
properly.
To reset the pan/tilt position, press the PAN-TILT
RESET button.

Zooming

Turn the dial on the upper part of the joystick.
Subject appears farther
When you perform pan/tilt operation while the camera is
in the telephoto mode, the moving speed of the image on
the screen may be a little jerky.
Movement of the
camera
Incline to the right.
Note
STANDBY flashes.
away. (Wide angle)
Note
Setting
Set DIP 2
switch 2 to
OFF.
Set DIP 2
switch 2 to
ON.
Subject appears closer.
(Telephoto)
11
Pan/Tilt and Zoom Operation
GB