Mounting The Lens - JVC TK-C1460B Instrucciones

Mounting the lens

Mount the lens according to the procedures described below.
3.
3
1
4
2
Attached 4 pin plugs
Lens
Pin No.
1
2
3
4
(b)
F
(c)
VIDEO
DC
2.
IRIS
VIDEO
DC
4.
1 3
2 4
CAUTION:
Always attach the fer-
rite core (supplied) to
the lens cable.
( Page 16)
DC IRIS
(does not contain EE amplifier)
Brake –
Brake +
Drive +
Drive –
1.
Before mounting a lens, check whether
it is a C-mount or CS-mount lens.
To change the mounting method, loosen
the back-focus locking screw (M 2.6)
using a Phillips head screwdriver, turn
the back-focus adjusting ring with your
fingers or the screwdriver and change
the mounting method.
As regards the dimension (b) of the area
to which the lens is to be installed as
illustrated on the left diagram, use the
one with less value than what's shown
in the table below.
For both the C-mount and CS-mount,
never use whatever exceeds the dimen-
sion (b), as such will not allow normal
installation and damage the inner part
of the camera, resulting in a malfunc-
tion.
Lens Flange back (c) Dimension (b)
C mount lens 17.526mm
CS mount lens 12.5mm
The F mark indicates a focal point.
2.
Mount the lens on the camera by turning
the lens clockwise. Adjust its position.
3.
When using an auto-iris lens with an EE
amplifier, turn the switch to the "VIDEO"
side. When no EE amplifier is equipped,
turn the switch to the "DC" side.
4.
If the lens has an auto-iris mechanism,
connect the lens cable after checking the
pin arrangement.
If the lens cable has a different type of
plug, use the 4-P plug supplied.
VIDEO IRIS
(contain EE amplifier)
9V [max 50mA]
NC
VIDEO
GND
5.5mm or less
5.5mm or less
1 3
2 4
E-15