Control By Black-White/Color Switching Signal From The Outside - JVC TK-C1460B Instrucciones

Control by Black-White/Color switching signal from the outside

Carry out the following setting when you link in motion the black-white/color switching of this
unit and infrared illumination, etc., using the switching signal from the outside control device.
+ -
1 2
TX+ TX- RX+ RX- AUX GND
A B
SYNC IN VIDEO OUT
POWER
TK-C1460B
MENU button
MENU
A C SE T L
I R S L E VE L I
A E V RA E G : P EAK
S UT H T ER E x DR
A C G MODE
L L U O X MODE
S NS E E U P
P R I O R I T Y
B C L
B&W/COLOR MODE
B&W/COLOR MODE
B&W
L E V E L
B&W: Make signal
COLOR: Break signal
C D
Y/C OUT
SEE INST-
RUCTION
MANUAL
It is requested that you consult our JVC dealer about connecting
devices, etc.
SET button
SET
CAMERA
SETUP
AWC
T I NGS
NORMAL
8 2 :
N RMAL O
/
2 d B 0
O F F
O F F
MO T I ON
E D I T 1
AUT O
NORMAL
Switching
signal
Outside control device
Set the B&W item to AUX.
1.
Select B&W/COLOR MODE on
the ALC SETTING screen.
2.
Press the SET button.
• The B&W/COLOR MODE screen
appears.
3.
Press either the
button and select the B&W
item.
4.
Press either the
button and set to "AUX".
Then, the AUX TERMINAL item on the
MODE SELECT screen is automatically
set to (B&W IN). Refer to
5.
Upon completion of setting,
press the MENU button.
• Then, the ALC SETTING screen is
brought back.
CAUTION:
When you use near infrared ray illumi-
nations, use a lens that is compatible
with the near infrared ray illuminations.
Any lens other than the compatible one
can result in out-of-focus due to such
characteristics.
Infrared illumination, etc.
Sensor or switch
button or the
button or the
Page 33.
E-41