Tabla de contenido
Publicidad
English
Technical Information
Water pressure
Recommended
Maximum
Hot water temp.
Recommended
Maximum
Flow rate
handshower
tub filler
* Please know and follow all applicable local plumbing
codes when setting the temperature on the water heater.
Installation Considerations
• For best results, Hansgrohe recommends that this
unit be installed by a licensed, professional plumber.
• Please read over these instructions thoroughly
before beginning installation. Make sure that you
have all tools and supplies needed to complete the
installation.
• Protection against backflow is provided by check
valve and an automatically resetting diverter.
• This trim is for use with rough #10452181 (not
included). The rough must be installed and the
finished floor surface completed and made
watertight.
• This unit is not anti-scald. If required by local code,
install in combination with an approved remote
pressure balance valve or other approved device.
2
15 - 75 PSI (0.1 - 0.5 MPa)
145 PSI (1 MPa)
120°-140° F (48° - 60° C)*
158°F (70° C)*
1.75 GPM (6.6 L/min)
5.3 GPM (20 L/min)
• To prevent scald injury, the maximum output
temperature of the shower mixing valve must be no
higher than 120°F (49°C). In Massachusetts, the
maximum output temperature can be no higher than
112° F (44°C).
• The handshower is for use with an automatically
compensating valve rated at 1.3 GPM (4.9 L/min)
or less.
• Keep this booklet and the receipt (or other proof
of date and place of purchase) for this product in
a safe place. The receipt is required should it be
necessary to request warranty parts.
Publicidad
Tabla de contenido
