Tabla de contenido
Publicidad
English
Technical Information
Water pressure
Recommended
Maximum
Hot water temp.
Recommended 120°-140° F*(48° -60° C*)
Maximum
Max. flow rate
Hole size in mounting surface
spout
valves
Max. depth of mounting surface 1³⁄₁₆" (30 mm)
* Please know and follow all applicable local plumbing
codes when setting the temperature on the water
heater.
Installation Considerations
• For best results, Hansgrohe recommends that
this unit be installed by a licensed, professional
plumber.
• Please read over these instructions thoroughly
before beginning installation. Make sure that
you have all tools and supplies needed to
complete the installation.
• The drain is suitable for most, but not all, lavatory
sinks sold in the United States and Canada.
• This drain is intended for use in a sink with an
overflow. If your sink does not have an overflow,
or if this drain is too small for the hole in your
sink, please refer to the instructions
included with the sink. Some sinks include
2
15 - 75 PSI (0.1 - 0.5 MPa)
145 PSI (1 MPa)
158°F*(70° C*)
1.2 GPM (4.5 L/min)
1⁵⁄₁₆" (34 mm)
1³⁄₁₆" (30 mm)
special drain installation instructions and/
or parts. Others require the use of a specialty
drain. Hansgrohe is not respnsible for the cost
of a specialty drain.
The hot and cold supply hoses included
with this faucet are for use with ⅜ stops.
If your stops are a different size, purchase
adapters at your local plumbing supply
store or home center. Adapters are not
available from Hansgrohe.
• Keep this booklet and the receipt (or other proof
of date and place of purchase) for this product
in a safe place. The receipt is required should it
be necessary to request warranty parts.
Publicidad
Tabla de contenido
