Preparing To Charge; Charger Location; Dc Connection Precautions - schulink SC1344 Manual Del Usuario

3.

PREPARING TO CHARGE

3.1 If necessary to remove battery from vehicle to charge, always remove grounded
terminal from battery first. Make sure all accessories in the vehicle are off, so as
not to cause an arc.
3.2 Be sure area around battery is well ventilated while battery is being charged.
3.3 Clean battery terminals. Be careful to keep corrosion from coming in contact with eyes.
3.4 Add distilled water in each cell until battery acid reaches level specified by battery
manufacturer. Do not overfill. For a battery without removable cell caps, such as valve
regulated lead acid batteries, carefully follow manufacturer's recharging instructions.
3.5 Study all battery manufacturer's specific precautions while charging and
recommended rates of charge.
3.6 Determine voltage of battery by referring to car owner's manual and make
sure that output voltage selector switch is set at correct voltage. If charger has
adjustable charge rate, charge battery initially at lowest rate. For a charger not
having an output voltage selector switch, determine voltage of battery by referring
to car owner's manual and make sure it matches output rating of battery charger.
4.

CHARGER LOCATION

4.1 Locate charger as far away from battery as DC cables permit.
4.2 Never place charger directly above battery being charged; gases from battery will
corrode and damage charger.
4.3 Never allow battery acid to drip on charger when reading electrolyte specific
gravity or filling battery.
4.4 Do not operate charger in a closed-in area or restrict ventilation in any way.
4.5 Do not set a battery on top of charger.
5.

DC CONNECTION PRECAUTIONS

5.1 Connect and disconnect DC output clips only after setting any charger switches
to "off" position and removing AC cord from electric outlet. Never allow clips to
touch each other.
5.2 Attach clips to battery and chassis, as indicated in sections 6 and 7.
• 4 •