GE 26 Manual Del Propietário página 4

About the controls with temperature settings.
Not all features are on all models. Your controls will look like one of the following:
Location of Dispenser Controls
Location of Internal Controls
Changing the Temperature
Dispenser models:
To change the temperature, press and release
the Adjust Freezer or Adjust Refrigerator pad.
The display will show the actual temperature.
Tap either the Adjust Freezer or Adjust Refrigerator
pad until the desired temperature is displayed.
Internal control models:
To change the temperature, press and release
the Freezer or Fridge pad. The display will show
the actual temperature. Tap either the Freezer or
Fridge pad until the desired temperature is displayed.
4
NOTE: The refrigerator is shipped with protective film covering the temperature
controls. If this film was not removed during installation, remove it now.
The temperature controls are preset in the factory at 38°F for the refrigerator
compartment and -2°F for the freezer compartment. Allow 24 hours for
the temperature to stabilize to the preset recommended settings.
The temperature controls can display both the SET temperature as well as
the actual temperature in the refrigerator and freezer. The actual temperature
may vary slightly from the SET temperature based on usage and operating
environment.
Dispenser Models
Internal Control Models
Once the desired temperature has been set,
the temperature display will return to the actual
refrigerator and freezer temperatures after
10 seconds. Several adjustments may be required.
Each time you adjust controls, allow 24 hours
for the refrigerator to reach the temperature you
have set.
Once the desired temperature has been set,
the temperature display will return to the actual
refrigerator and freezer temperatures after
10 seconds. Several adjustments may be required.
Each time you adjust controls, allow 24 hours
for the refrigerator to reach the temperature
you have set.