Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
The cover has markings to indicate its position.
Depending on the size of the threaded rod, put the
cover in the position as shown in the table as well as the
rod guide.
Position
1
2
W5/16, W1/4, 5/16-18UNC, 1/4-20UNC,
Quitting the cutting in the middle
CAUTION:
Never try to pull out the tool forci-
bly from the threaded rod. It may cause unexpected
start up which cause personal injury or damage to the
cutting die and tool.
When quitting the cutting in the middle, set the revers-
ing switch lever to the reversing position and pull the
switch trigger until the threaded rod is completely
released from the cutting dies.
MAINTENANCE
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before attempting to perform inspection or
maintenance.
NOTICE:
Never use gasoline, benzine, thinner,
alcohol or the like. Discoloration, deformation or
cracks may result.
To maintain product SAFETY and RELIABILITY,
repairs, any other maintenance or adjustment should
be performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
Replacing the cutting dies
NOTICE:
Replace the both cutting dies at the
same time. Replacing the one side of the cutting die
may generate burr on the threaded rod.
Replace the cutting dies when it is chipped, deformed,
or the cutting gets dull. To replace, follow the instruc-
tions in the section for installing the cutting dies.
1
► 1. Chipping 2. Deformation
Size of threaded rod
W3/8, 3/8-16UNC, M10
M8, M6
2
One cutting die has two cutting edges and thick side
and thin side. Switch the installation positions of the
cutting dies if you have not used the other sides of the
cutting edges.
► 1. Cutting edge 2. Thin side 3. Thick side
Carrying/storing the tool
CAUTION:
When the tool is not used, always
attach the supplied cover to the cutting portion.
Attach the cover when carrying the tool.
When storing the tool, remove the battery cartridge and
the guide scale from the tool. Clean dust on the cutting
dies and the moving part. After that, attach the cover.
► 1. Cover
12 ENGLISH
2
1
3
1
Publicidad
Tabla de contenido
