Installation And Grounding Instructions - Panasonic NN-SA631B Instrucciones De Operación

IP3518_39Y10AP_36_110630:IP3518_39Y10AP_00_110317.qxd 2011-6-30 Jerry
installation and grounding
examine your oven
Unpack oven, remove all packing material and examine the oven for any
damage such as dents, broken door latches or cracks in the door. Notify dealer
immediately if oven is damaged. do not install if oven is damaged.
Placement of oven
1. The oven must be placed on a flat, stable surface. Place the front surface of
the door three inches or more from the counter top edge to avoid accidental
tipping of the microwave oven during normal use. For proper operation, the
oven must have sufficient air flow. Allow 3-inches (7.6 cm) of space on both
sides of the oven and 1-inch (2.5 cm) of space on top of the oven.
(a) do not block air vents. If they are blocked during operation, the oven
may be overheated and damaged.
(b) do not place oven near a hot, damp surface such as a gas or electric
range, or dishwasher.
(c) do not operate oven when room humidity is excessive.
2. This oven is manufactured for household use only. It is not approved or tested
for mobile vehicle, marine, or commercial use.
3. NN-SA631B/NN-SA631W :
This oven is not intended for built-in operation and is not approved or tested
for mobile,vehicle, marine, or commercial use.
installation
1. do not block air vents. If they are blocked during operation, the oven may
overheat. If the oven overheats, a thermal safety device will turn the oven off.
The oven will remain inoperable until it has cooled.
2. If the oven is designed for installation into a wall cabinet by using the proper
trim kit available from a local Panasonic dealer, follow all instructions packed
with the kit.
WaRninG
iMProPer use of the grounding Plug can result in a risK of
electric shocK.
Consult a qualified electrician or service person if the grounding instructions are not
completely understood, or if doubt exists as to whether the appliance is properly grounded.
If it is necessary to use an extension cord, use only a three wire extension cord that has a
three prong polarized grounding plug, and a three slot receptacle that will accept the plug
on the appliance. The marked rating of the extension cord should be equal to or greater
than the electrical rating of the appliance.
grounding instructions
this aPPliance Must be grounded. In the event of an electrical short circuit,
grounding reduces the risk of electric shock by providing an escape wire for the electric
current. This appliance is equipped with a cord having a grounding wire with a grounding
plug. The plug must be plugged into an outlet that is properly installed and grounded.
• Plug into properly installed and grounded 3 prong outlet.
• do not remove ground prong.
• do not use an adapter.
instructions
4
16:45 Page 4