Garland CHIPPER 1280 QG Manual De Instrucciones página 40

English
The machine is designed only for outdoor use. Avoid
using the machine in outdoor areas with a high
probability of exhaust fumes.
The machine must be used by only one person at a
time.
Never insert your hands in the entry chute until the
machine has been stopped and the blades have
stopped rotating.
The pieces of wood that
might have got stuck
transversally must only be
removed when the machine
has been stopped and
the blades have stopped
rotating.
In the case that the rotor is blocked by a piece of
wood:
- Disconnect the machine, remove the cover of the
rotor axis and turn the rotor axis a few degrees
with a specifi c spanner designed for this.
- After this, remove the piece using a stick or
something long.
ATTENTION: DO NOT INTRODUCE YOUR HANDS IN
THE ROTOR
Never leave the machine unattended or functioning.
Stop the engine and spark plug before replacing the
blades or counter blades.
After an hours work, check the screws and nuts are
still well tightened. If not so, tighten them.
Always use original spare parts, if not you shall lose
your warranty.
The machine should only be repaired by an authorized
after sales dealer.
6.4.2. STARTING THE ENGINE
Before starting engine make sure check the engine oil
and fuel tank before starting the engine.
6.4.2.1. COLD-STARTING THE ENGINE
A. Place the ON/OFF switch in the "ON" position.
B. Place the fuel tap in the open position.
40/160