Kenwood IC600 Serie Manual De Instrucciones página 6

All manuals and user guides at all-guides.com
know your Kenwood
steam station
lock for continuous steam
steam button
temperature control with
indicator light
soleplate
water tank cover
water tank
water tank guard rail
iron rest
cord cactus locations
power supply cord
cord storage
steam supply cord
boiler cap
variable steam control
low water indicator light
on/off button
ready to steam indicator light
outlet for Multicare accessory kit*
carry handle
cord cactus
* The Multicare accessory kit model
ICK01 is not included in pack but
can be purchased separately by
contacting the shop where you
purchased the steam station.
using your steam station
1 Place the steam station on the
support of the ironing board or any
other stable surface nearby with the
iron sitting on the iron rest. Make sure
the steam station is unplugged and
that the power and steam supply
cords are unrolled and not kinked.
2 Fit the cord cactus into one of the
cord cactus locations. Place the
steam supply cord into one of the
grooves on the other end of the cord
cactus. This will keep the cord in an
upright position.
filling with water
Either
1 Lift off the water tank cover and fill
with water. Replace the cover.
Or
2 Remove the tank by lifting off. Lift off
the cover, then fill the tank under the
tap. Re-fit the cover. Replace the
tank into its original position by
gently pushing into place.
●
Filtered water is best as it reduces
limescale, prolonging the life of your
steam station (Kenwood water filters
are widely available). Alternatively
use 50% tap water and 50% distilled
water.
●
Do not add anything else to the
water such as water from clothes
driers, scented water, water from
refrigerators, air conditioners,
batteries, bottled mineral water or
rain water. These contain organic
waste or mineral elements that
become concentrated when heated
and cause spitting, brown staining or
premature wear to the steam station.
●
If you need to refill your steam
station during use, we recommend
the empty water tank is removed for
filling. If filled whilst fitted, always
unplug the steam station first.
choosing the right
temperature
Follow the clothes label advice.
Match the dots on the label to the
dots on the temperature control. If
there's no label, here's a guide on
which temperature to choose:
hints
●
Start on clothes needing the lowest
temperature, then work upwards.
(This lowers the risk of burning
something because an iron switched
from 'hot' to 'cool' takes time to
cool down.)
●
For mixed fibres, eg cotton
polyester ● , use the lowest suitable
temperature ● .
3
●●● and