Fimar GYR40 Manual De Uso Y Mantenimiento página 44

▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬
Burner nozzle replacement
1. Loosen the screws and remove the rear
panel.
2. Unscrew the nozzle (A) and replace it
with the one suited for the gas used.
3. Reassemble the rear panel and secure it
with the screws.
Heat power adjustment to minimum
METHANE GAS powered appliance
1. Remove the knob.
EN
2. Loosen the screw (B) (about 2/3 turn) and
assemble the knob.
3. Turn on the burner , rotate the knob to the
minimum power position.
4. Pull out the knob and tighten the screw
(B) until the flame is stable.
5. Assemble the burner control knob and rotate it to turn it off.
6. Repeat minimum adjustment on the other burner.
LIQUID PROPANE GAS powered appliance (LPG)
1. Pull out the knobs.
2. Fully tighten the minimum adjustment screw (B).
3. Assemble the knobs.
4. Turn on the appliance and make sure the flame is stable.
5. Turning off the appliance
GYROS (GAS POWERED)
B
- 20 -
A
IDM-34605600600.pdf
English language