Black and Decker WV3650 Manual De Instrucciones página 5

As soon as the ambient
temperature has decreased, the
charger will resume operating.
The charger is intended for
indoor use only.
Read the manual carefully
before using the appliance.
Features
1. On/off switch
2. Release button
3. Dust bowl
4. Hanging loop
Fig. A
5. Crevice tool
6. Wet pick-up accessory
Installation
Fitting the wall hook to the wall (fig. B)
The wall hook can be fitted to the wall to
provide a convenient storage and
charging point for the appliance.
Warning! Do not fit the wall hook directly
over a mains supply. Ensure the cord has
a loop when the charger is connected to
the mains.
Assembly
Fitting the accessories (fig. A & C)
These models are supplied with the
following accessories:
- a crevice tool (5) for confined spaces
- a wet pick-up accessory (6) for wet
spills
To fit an accessory, proceed as follows:
Take the accessories from the
x
appliance.
Insert the appropriate accessory into
x
the front of the appliance.
You may refit the other accessory by
clicking it into the accessory holder.
To refit both accessories:
Slide the crevice tool into the wet
x
pick-up accessory.
ENGLISH
Push the accessories down until they
x
click into place.
Use
The appliance can be charged while
x
placed on a worktop or hung on the
wall using the wall hook provided.
Before first use, the battery must be
x
charged for at least 16 hours.
Leave the appliance connected to
x
the charger whenever it is not in use.
Charging the battery (fig. D)
Make sure that the appliance is
x
switched off. The battery will not be
charged with the on/off switch in the
on position.
Insert the charger plug (8) into the
x
charger connector (9) at the rear of
the appliance.
Plug in the charger (7). Switch on at
x
the mains.
Leave the appliance to charge for at
x
least 16 hours.
Whilst charging, the charger may become
warm. This is normal and does not
indicate a problem. The appliance can be
left connected to the charger indefinitely.
Warning! Do not charge the battery at
ambient temperatures below 4 °C or
above 40 °C.
Switching on and off (fig. E)
To switch on, slide the on/off switch
x
(1) forward.
To switch off, slide the on/off switch
x
back.
Wet pick-up (fig. A)
Use the wet pick-up accessory (6) on
non-absorbent surfaces.
For best results when using this accessory,
hold the appliance at an angle of 45° and
pull it slowly towards you. On absorbent
surfaces, such as carpet, your appliance
will pick up wet spills better without the
accessory.
Emptying the dust bowl (fig. F & G)
Press the release button (2) and
x
remove the dust bowl (3).
5