Torque Adjustment; Work Light - Rebel RB-1002 Manual Del Usuario

Torque adjustment

The torque can be adjusted in 21 steps. To set the desired torque rotate the adjusting ring
(2) right/left so that the appropriate number is opposite the arrow.
Work mode selection
The power tool has three work modes: driving in/loosening screws, drilling and impact.
Set the work mode adjusting ring (3) in the position corresponding the type of work being
performed:
• driving in/loosening screws
• drilling
• impact
Speed range selection
The power tool has been equipped with the speed range switch (4). There are two ranges
available. To set the speed range, push the switch forward (2- higher speed) / backward
(1- lower speed).
Rotation direction adjustment
The power tool has been equipped with rotation direction switch (7):
• To achieve right rotation (driving in screws/drilling), push the rotation direction switch
(7) maximally left.
• To achieve left rotation (loosening screws), push the rotation direction switch (7)
maximally right.
Switching the power tool on and off
• Pressing the ON/OFF (6) switch will activate the power tool.
• Releasing the ON/OFF (6) switch will stop the power tool.
• Set the rotation direction switch (7) to the middle position to lock the movement of the
ON/OFF switch. It cannot be activated in this position.

Work light

There is a work light (5) above the ON/OFF switch. It turns on when the ON/OFF switch is
pressed. It turns off when the ON/OFF switch is released.
Warning: The work light is intended to illuminate the power tool's direct area of working
operation and is not suitable for other purposes. Do not look directly into the light. Risk
of eye damage!
EN 38