Protecting The Environment - Black+Decker BDCH188 Manual De Instrucciones

ENGLISH
Drilling in masonry (fig. D & E)
For drilling in masonry, set the collar (3) to the ham-
u
mer drilling position by aligning the symbol with the
marking.
Slide the speed selector (5) towards the front of the
u
tool (2nd gear).
Speed selector (fig. E)
For drilling in steel and for screwdriving applications,
u
slide the speed selector (5) towards the rear of the tool
(1st gear).
For drilling in materials other than steel, slide the
u
speed selector (5) towards the front of the tool (2nd
gear).
Drilling/screwdriving
Select forward or reverse rotation using the forward/
u
reverse slider (2).
To switch the tool on, press the switch (1). The tool
u
speed depends on how far you press the switch.
To switch the tool off, release the switch.
u
Hints for optimum use
Drilling
Always apply a light pressure in a straight line with the
u
drill bit.
Just before the drill tip breaks through the other side of
u
the workpiece, decrease pressure on the tool.
Use a block of wood to back up workpieces that may
u
splinter.
Use spade bits when drilling large diameter holes in
u
wood.
Use HSS drill bits when drilling in metal.
u
Use masonry bits when drilling in soft masonry.
u
Use a lubricant when drilling metals other than cast
u
iron and brass.
Make an indentation using a centre punch at the
u
centre of the hole to be drilled in order to improve
accuracy.
8
(Original instructions)
Screwdriving
Always use the correct type and size of screwdriver
u
bit.
If screws are difficult to tighten, try applying a small
u
amount of washing liquid or soap as a lubricant.
Always hold the tool and screwdriver bit in a straight
u
line with the screw.
Maintenance
Your BLACK+DECKER tool has been designed to operate
over a long period of time with a minimum of maintenance.
Continuous satisfactory operation depends upon proper
tool care and regular cleaning.
Your charger does not require any maintenance apart from
regular cleaning.
Warning! Before performing any maintenance on the
tool, remove the battery from the tool. Unplug the charger
before cleaning it.
Regularly clean the ventilation slots in your tool and
u
charger using a soft brush or dry cloth.
Regularly clean the motor housing using a damp cloth.
u
Do not use any abrasive or solvent-based cleaner.
Regularly open the chuck and tap it to remove any
u
dust from the interior.

Protecting the environment

Z
Separate collection. This product must not be
disposed of with normal household waste.
Should you find one day that your BLACK+DECKER
product needs replacement, or if it is of no further use to
you, do not dispose of it with household waste. Make this
product available for separate collection.
z
Separate collection of used products and
packaging allows materials to be recycled and
used again.
Re-use of recycled materials helps prevent en-
vironmental pollution and reduces the demand
for raw materials.