Beurer EM 28 Instrucciones De Uso página 29

Problem Possible cause
The intensity on the
device is set too
high.
Water contact elec-
trodes are not suffi-
Stimulation
ciently moist.
is uncom-
fortable.
Connection cable is
worn/faulty.
Water contact elec-
trodes are worn/
faulty.
Irregular Connection cable
stimulation. faulty.
Water contact elec-
Stimulation
trodes are not posi-
is ineffec-
tioned correctly on
tive.
the skin.
Solution
Lower the intensity
on the device.
Switch off the
device. Moisten
electrodes.
Replace the
connection cable.
Replace the wrist
cuff.
Reduce the inten-
sity and rotate the
connection cable
on the socket by
90°. If addition-
al power failures
occur, replace the
connection cable.
Remove water
contact electrodes
and reposition on
the skin. Ensure
there is sufficient
contact with the
skin.
29
Problem Possible cause
The cuff is not posi-
tioned correctly on
the skin.
The skin
The cuff is dirty.
turns red
and/or a
stabbing
One of the water
pain occurs.
contact electrodes
has a scratch.
Water contact elec-
trodes are not suffi-
ciently moist.
The cuff has come
loose from the skin.
Stimulation The connection
stops during cable has worked
use. itself loose.
The batteries are
empty.
Solution
Ensure that the
cuff sits securely
on the skin and
cannot move.
Clean the cuff as
described in these
instructions for
use.
Replace the cuff.
Switch off the
device. Moisten
electrodes.
Stop the applica-
tion and reposition
the wrist cuff.
Stop the applica-
tion and reinsert
the connection
cable.
Replace the
batteries on the
control unit.