First Use - Nevadent NAZ 2.4 C3 Instrucciones De Uso

First use

NOTE
Before starting to use the appliance, check that it is in fault-free condition . You
must not use the appliance if it has any faults .
1) Insert the power plug into the socket .
2) Before the first use, clean the new brush heads 1 with clear water .
3) Open the lid 0 of the brush holders q and place the replacement brush
heads in the four slots provided . Close the lid 0 again .
4) Place the handset on the charger 8 so that it slides onto the pin on the
base .
5) Allow the handset to charge up for around 14 –16 hours before using it for
the first time . The charging light 7 on the front of the handset lights up red
during the charging process .
6) Use the handset repeatedly without charging the battery until the performance
becomes noticeably weaker or the toothbrush stops working and the charge
indicator 7 flashes red . Then recharge the battery for 14 –16 hours . When
the appliance is fully charged, the charge indicator 7 lights up green .
7) Charge and discharge the toothbrush completely 3 times . The battery will
have then reached its full capacity .
8) You can now leave the handset in the charger 8 after every use, so as to
always have full power available .
■ 48 │ GB │ MT
NAZ 2.4 C3