Fitting/Removing Brush Heads; Operation - Nevadent NAZ 2.4 C3 Instrucciones De Uso

Fitting/removing brush heads

■ To remove the brush head 1, pull it upwards and off the drive shaft 2 .
■ When fitting the brush head 1, ensure that the drive shaft 2 on the handset
slides precisely into the socket on the brush head 1 .
Push the brush head 1 down until it completely covers the drive shaft 2 .
NOTE
You can order replacement brush heads from our Service department (see
section "Ordering replacement parts") .
You can also use the brush heads for the models NAZ 3 .7 A1 and
DAZD 3 .7 LI B2 (also available from Lidl) .
The toothbrush is also compatible with brush heads from the following
©
Oral B
Oral-B Ortho, Oral-B Precision Clean, Oral-B 3D White, Oral-B Cross Action,
Oral-B Stages Power, Oral-B Sensitive, Oral-B Deep Cleaning .
*Oral-B is a registered trademark of Procter & Gamble .

Operation

This toothbrush has 3 different power levels:
–
"Clean": normal speed, orange "Clean" LED 4
For cleaning the teeth .
–
"Sensitive": slow speed, green "Sensitive" LED 5
For cleaning the teeth if you have sensitive gums .
–
"Massage": slow speed with short breaks, yellow "Massage" LED 6
For massaging the gums .
■ Press the On/Off switch 3 once to activate the "Clean" mode . The "Clean"
LED 4 lights up .
■ Press once more to switch to "Sensitive" mode . The "Sensitive" LED 5 lights up .
■ Press a third time to switch to "Massage" mode . The "Massage" LED 6
lights up .
■ To switch the toothbrush off, press the On/Off switch 3 once more .
NAZ 2.4 C3
* models:
GB │ MT │ 49 ■