Icm Placement Instructions - FRIGOGLASS Smart-300 LC Manual De Usuario

ENG
3.1

ICM placement instructions

a. After unpacking, check the cabinet for any damage caused during transportation. In the event of
damage, please contact the forwarding company.
b. Always ensure that your merchandiser is installed on a stable surface/floor and is properly
leveled. There are 2 adjustable feet for all models at the front under the chassis apart from
Smart-1300 which has 3 adjustable feet. The level foot at the middle of the cooler must be
adjusted in such a way that the lower edges of the internal cabin are aligned. The below given
check points must be on the same line.
Please, adjust until the ICM levels and check using a spirit level, if available. Take necessary
precautions if lifting is needed during installation. Keep unauthorised people away from the cooler until
installation is completed.
c. The merchandiser must stand upright for at least 1 hour after transportation and prior to start-up.
This gives the oil time to run back to the compressor after transit and installation.
d. Allow a minimum gap of 100mm at the back. To make that possible, please turn the back spacer
as shown below.
e. Do not place anything on top of the cooler.
10
Do not place the merchandiser:

in direct sunlight or near heat sources (radiators, stoves & other
heating equipment)

outdoors, without protection from rain that prevents water falling
directly on the merchadiser

in climate conditions for which it is not certified

in extreme environmental conditions (i.e. exposure to saline
humidity)

on a surface with an angle more than 5
o
Check points