Machining Tips; Bench Stand Removal & Setup; Special Shoe Sets For Fse 1.0 - Wachs FSE 1.0 Manual De Instrucciones

FSE FITTING SQUARING MACHINE
SECTION V
F.

Machining Tips

1. For precision machined lengths leave motor off. Ro-
tate feed knob until tool touches end of work. Note
location on index gauge. Retract feed knob. Add
required measurement to observed number on feed
knob. With power on, monitor index gauge. Length
accuracy: to ± .002".
2. Be careful of cutting edge of tool bit. Edge is sharp
and can be damaged.
3. Check tool bit often. If work edge develops burr,
tool bit may be worn.
4. Keep consistent pressure on feed knob.
5. To break off long chips, retract feed knob for a sec-
ond and return to feeding.
6. "Chatter" can be controlled by changing feed rate
of tool. Increasing feed and reducing speed will solve
this problem.
SECTION VI
CAUTION: Unplug machine from power
source before performing any service.
1. FSE maintenace consists of cleaning and inspec-
tion for damage and wear. No grease required for
clamping system. Cutter head bushing should be
checked for looseness. Feed nut and thrust bearing
should be checked for end float. Check power cord
for wear. Replace if worn or cracked.
FSE SETUP & OPERATING PROCEDURES
FSE MAINTENANCE
G. Bench Stand Removal & Setup
1. To remove stand, loosen 1/2-13 x 2-1/2" FHCS. To
reinstall stand, slide FHCS through base plate and
support. Thread FHCS into FSE main housing and
tighten.
H. Special Shoe Sets for FSE
1. Microfittings require shorter grip lengths then stan-
dard .250". Shoes requiring .165" can be ordered.
These shoes come in
(Extended tooling required. Consult factory for availability.)
10
(CONT.)
1/8", 3/16", 1/4", 3/8" and 1/2".