Wachs FSE 1.0 Manual De Instrucciones página 4

FSE FITTING SQUARING MACHINE
SECTION II
Read the Following thoroughly before proceeding
Since 1883, EH Wachs has built a reputation for qual-
ity and a commitment to consumer satisfaction. In accor-
dance with this, Wachs must take on the added responsi-
bility of doing our best to assure the safest use of our equip-
ment.
We have assembled a list of safety reminders to aid in
creating the safest possible working environment. We rec-
ommend that the precautionary steps listed there be
closely observed.
1. READ THE OPERATING MANUAL!!
Reading the setup and operating instructions prior to
beginning the setup procedures can save valuable time
and help prevent injury to operators or damage to
machines.
2. INSPECT MACHINE & ACCESSORIES!
Prior to machine setup physically inspect the machine
and it's accessories. Look for worn tool slides, loose
bolts or nuts, lubricant leakage, excessive rust, etc. A
properly maintained machine can greatly decrease the
chances for injury.
3. ALWAYS READ PLACARDS & LABELS!
All placards, labels and stickers must be clearly legible
and in good condition. Replacement labels can be
purchased from the manufacturer.
4. KEEP CLEAR OF ROTATING PARTS!
Keep hands, arms and fingers clear of all rotating or
moving parts. Always turn machine off before attempt-
ing any adjustments requiring contact with the machine
or it's accessories.
5. SECURE LOOSE CLOTHING & JEWELRY!
Loose fitting clothing, jewelry; long, unbound hair can
get caught in the rotating parts on machines. By keeping
these things secure or removing them you can greatly
reduce the chance for injury.
6. KEEP WORK AREA CLEAR!
Be sure to keep the work area free of clutter and
nonessential materials. Only allow those personnel
directly associated with the work being performed to
have access to the area if possible.
SAFETY INSTRUCTIONS
ALWAYS WEAR PROTECTIVE EQUIPMENT:
For additonal information on eye and face protection, refer to
federal OSHA regulations, 29 Code of Federal Regulations,
Section 1019.133., Eye and Face Protection and American
National Standards Institute, ANSI Z87.1, Occupational and
Educational Eye and Face Protection. Z87.1 is available
from the American National Standards Institute, Inc., 1430
Broadway, New York, NY 10018
Hearing protectors are required in high noise areas, 85dBA
or greater. The operation of other tools and equipment in the
area, reflective surfaces, process noises and resonant struc-
tures can substantionally contribute to and increase the
noise level in the area. For additional information on hearing
protection, refer to federal OSHA regulations , 29 Code of
Federal Regulations, section 1910.95, Occupational Noise
Exposure and ANSI S12.6 Hearing Protectors.
Use minimum hand grip force.
!
Keep wrists straight
!
Avoid prolonged, continuous vibration exposure
!
Avoid repeated bending of wrists and hands.
!
Keep arms and hands warm and dry.
!
2.
WARNING
Impact resistant eye protection
must be worn while operating or
working near this tool.
CAUTION
Personal hearing protection is re-
quired at all times when operating
or working near this tool.
CAUTION
Some individuals are suseptible to
disorders of the hands and arms
when exposed to tasks which in-
volve repetitive motions and/or vi-
bration. Disorders such as Carpal
Tunnel Syndrome and Tendonitis
can be caused or aggravated by
repetitious, forceful exertions of the
hands and arms.