Tabla de contenido
Publicidad
FSE TROUBLE SHOOTING
SECTION VIII
Trouble
Possible Cause
Remedy
Machine Won't Run ..................... Power Unit Not Connected .............................. Check Power Cord & Connection
Work Piece Shifts Under ............ Loose Shoe Clamp ........................................... Check Tension on Shoe Clamp Handle
Cutting Load.
Poor Workpiece End Quality ......... Dull or Chipped Tool Bit .................................... Replace Tool Bit.
Machine Chatters During Cut ....... RPM Speed of Tool Head ................................. Refer to Section on Machining Tips.
is Set Too Fast or Feed Rate
is Too Light.
Chip Runs Up Workpiece I.D. ....... Improper Tool Bit Installation ............................. Refer to Tool Bit Installation Proce-
edure ( Section 5).
12
Publicidad
Tabla de contenido
