ENGLISH
Repairs
This tool complies with relevant safety requirements. Repairs should only be carried out by
qualified persons using original spare parts; otherwise this may result in considerable danger
to the user.
Additional safety instructions for non-rechargeable batteries
Warning! Batteries can explode or leak, and can cause injury or fire. Observe the
instructions as described below.
Warning! Ensure the switch is in the off position before inserting the batteries. Inserting
batteries into power tools and appliances that have the switch on invites accidents.
Warning! Under abusive conditions, liquid may be ejected from the battery, avoid contact.
If contact accidentally occurs, flush with water. If liquid contacts eyes, additionally seek
medical help. Liquid ejected from the battery may cause irritation or burns.
Carefully follow all instructions and warnings on the battery label and package.
Always place batteries correctly according to the polarity (+ and -) as marked on the
battery and the product.
Do not short-circuit the battery terminals.
Do not attempt to charge non-rechargeable batteries.
Do not mix old and new batteries. Replace all of the batteries at the same time with new
batteries of the same brand and type.
Keep batteries out of reach of children.
Remove batteries if the product will not be used for several months.
Never attempt to open for any reason.
Do not store in locations where the temperature may exceed 40 °C.
When disposing of batteries, follow the instructions given in the section "Protecting the
environment".
Do not incinerate the batteries.
Additional safety instructions for pipe and wire detectors
Do not use the tool to detect AC voltage in uninsulated, exposed or free wires.
Do not use the tool as a substitute for a voltmeter.
Be aware that the tool may not always properly detect all pipes and wires. The following
conditions can cause inaccurate results:
- Low battery
- Thick walls with thin pipes or wires
- Very thick walls
- Very deep wires or pipes
6