Connecting The Lines; Preparing The Filter System - Steinbach Comfort 50 Manual Original

To connect a swimming pool hose to the pump
or filter vessel, proceed as follows:
1. Guide a hose clamp over the hose.
2. Push the hose onto the hose connection.
3. Fix the hose clamp on the hose connection
using a Phillips screwdriver PH1.
The swimming pool hose is connected.
To connect a swimming pool hose to the hose
adapter of the pump or filter vessel, proceed
as follows:
1. Screw the hose adapter into the connection
thread.
2. Guide a hose clamp over the hose.
3. Push the hose onto the hose adapter.
4. Fix the hose clamp on the hose adapter
using a PH 1 Phillips screwdriver.
The swimming pool hose is connected to the hose
adapter.
To screw an INTEX swimming pool hose (not
included in the package contents) onto the
pump or filter vessel, proceed as follows:
1. Screw the adapter for INTEX pools or the
return line adapter for INTEX pools into the
connection thread.
2. Screw the hose onto the adapter.
The INTEX swimming pool hose is connected.

Connecting the lines

Prepare the following components:
- Pressure line
14
- Return, backflush and suction line (not included in the package contents)
- Assembly materials for the lines
To connect the lines to the pump and filter vessel (see Figure A), proceed as follows:
1. Route the return and suction line from the pool to the filter system.
2. Route the backflush line from the duct connection to the filter system.
Observe the markings right at the line connections of the valve head.
The lines are connected.

Preparing the filter system

1. Press and hold down the valve lever
2. Set the valve lever to the "RÜCKSPÜLEN" (BACKFLUSH) position and release it.
3. Allow the filter vessel
on the valve head
35
to fill with water until the water runs out of the "WASTE"
6
7
8
9
.
1
backflush line.
34
35