Setup; Setting Up The Printer; Loading The Media - Sartorius YDP30 Instrucciones De Manejo

3. Setup

3.1 Setting Up the Printer

1. Place the printer on a flat, secure surface.
2. Make sure the power switch is set to "off."
3. Connect the printer to the balance with the provided cable.
4. Plug the power cord into the AC power cord socket at the rear of the printer,
and then plug the power cord into a properly grounded power outlet.
Please switch OFF the printer power switch before plugging the power cord into
printer power jack.
When using the RS-232C interface and cable, refer to
of the serial interface parameters.

3.2 Loading the Media

3.2.1 Loading the Media
1. Open the printer top cover by pulling the tabs located on each side towards the
front of the printer, and then lift the top cover to the maximum open angle.
2. The media holder can be used for 1" and 1.5" media cores by rotating the upper
part of the label holder 180 degrees clockwise.
3. Adjust the media holders to the label roll width.
Place the roll between the holders and lock them onto the core.
Setup
t
Section 4.3 for setup
Operating Instructions YDP30 7