Makita MHP161 Manual De Instrucciones página 4

7. Do not leave the tool running. Operate the tool
only when hand-held.
8. Do not touch the bit or the workpiece
immediately after operation; they may be
extremely hot and could burn your skin.
9. Some material contains chemicals which may
be toxic. Take caution to prevent dust
inhalation and skin contact. Follow material
supplier safety data.
SAVE THESE INSTRUCTIONS.
WARNING:
DO NOT let comfort or familiarity with product
(gained from repeated use) replace strict adherence
to safety rules for the subject product. MISUSE or
failure to follow the safety rules stated in this
instruction manual may cause serious personal
injury.
Symbols
The followings show the symbols used for tool.
volts
amperes
hertz
alternating current
no load speed
Class II Construction
revolutions or reciprocation per minute
number of blow
ASSEMBLY
Installing side grip (auxiliary handle)
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before installing or removing the side
grip.
2
3
5
011089
Always use the side grip to ensure operating safety.
Install the side grip so that the teeth on the grip fit in
USD202-2
between the protrusions on the tool barrel. Then tighten
the grip by turning clockwise at the desired position. It
may be swung 360° so as to be secured at any position.
Installing or removing drill bit
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before installing or removing the bit.
1
011090
To install the bit, place it in the chuck as far as it will go.
Tighten the chuck by hand. Place the chuck key in each
of the three holes and tighten clockwise. Be sure to
tighten all three chuck holes evenly. To remove the bit,
turn the chuck key counterclockwise in just one hole,
then loosen the chuck by hand.
After using the chuck key, be sure to return it to the
original position.
4
1
4
6
2
1. Grip base
2. Teeth
3. Side grip
(auxiliary
handle)
4. Protrusion
5. Loosen
6. Tighten
1. Drill chuck
2. Chuck key