Heath Zenith 595-5684-09 Manual Del Usuario página 5

4. To change the code, either (For models with 2 push buttons, change code
setting in both push buttons to match chime.):
• Add a jumper to the same location on both the push button and the chime
or...
• Remove a jumper from the same location on both the push button and the
chime or...
• Move a jumper on the push button from one location to another. Move the
corresponding jumper on the chime to match the new location in the push
button.
Example: Move jumper at location "5" to location "4" on both the push
button and the chime.
Note: Code positions 1 through 7 must be exactly the same for both the
push button and chime for this system to function.
Note: Unit will come factory set with jumpers in locations 5, 6, and 7 on the
push button and on the chime (see Figure 5).
The range of the wireless chime can vary with location, temperature, and
battery condition.
Remove screw to
open access door
Back of Chime
595-5684-09
* Code Settings 1-7
Must Match Both Push
Button and Chime
Note: Some models might require the use of
tweezers to remove and replace the jumpers.
Figure 5
-5-
Inside Push
Button