Technical Data; Noise Information; Vibration Information - KRESS KUC50 Manual De Instrucciones

TECHNICAL DATA

Type Designation: KUC50 KUC50.2 KUC50.91
(C50 designation of machinery, representative
of hammer)
Voltage
No load speed
Impact rate
Maximum clamping
capacity
Impact energy
Charging time
Battery capacity
Steel
Max.
drilling
Wood
capac-
ity
concrete
Machine weight
**Voltage measured without workload. Initial battery
voltage reaches maximum of 20 volts. Nominal
voltage is 18 volts.
10
EN

NOISE INFORMATION

A weighted sound pressure
A weighted sound power
K &K
pA wA
Wear ear protection.
VIBRATION
INFORMATION
Vibration total values (triax vector sum) determined
according to EN 60745:
Mode
description
Hammer drilling
into concrete
The declared vibration total value may be used for
comparing one tool with another, and may also be used
in a preliminary assessment of exposure.
WARNING: The vibration emission value during
actual use of the power tool can differ from the
declared value depending on the ways in which the tool
KUC50
KUC50.91
KUC50.2
20V Max**
0-1700/min
0-5300bpm
20 mm
1.7 J
45min
4.0 Ah Li-ion
13 mm
20 mm
20 mm
1.9kg
L = 86,3 dB(A)
pA
L = 97,3 dB(A)
wA
Vibration emission
Uncertainty K
value
a = 14,251m/s² K = 1.5 m/s²
h,HD
is used dependant on the following examples and other
variations on how the tool is used:
How the tool is used and the materials being cut or
drilled.
The tool being in good condition and well maintained
Using the correct accessory for the tool and ensuring it
is sharp and in good condition.
The tightness of the grip on the handles and if any anti
vibration accessories are used.
And the tool is being used as intended by its design
and these instructions.
This tool may cause hand-arm vibration
syndrome if its use is not adequately managed
WARNING: To be accurate, an estimation of
exposure level in the actual conditions of use
should also take account of all parts of the operating
cycle such as the times when the tool is switched off
/
and when it is running idle but not actually doing the
/
job. This may significantly reduce the exposure level
over the total working period.
Helping to minimise your vibration exposure risk.
ALWAYS use sharp chisels, drills and blades
Maintain this tool in accordance with these
instructions and keep well lubricated (where
appropriate)
1.35kg
If the tool is to be used regularly then invest in anti
vibration accessories.
Plan your work schedule to spread any high vibration
tool use across a number of days.
ACCESSORIES
Battery pack
(KAB21)
Charger
3 dB(A)
(KAC21)
Keyless
chuck with
SDS adaptor
We recommend that you purchase your accessories
from the same store that sold you the tool. Choose the
type according to the work you intend to undertake.
Refer to the accessory packaging for further details.
Store personnel can assist you and offer advice.
OPERATING
INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
Intended Use
The machine is intended for hammer drilling in
concrete, brick and stone. It is also suitable for drilling
without impact in wood, metal, ceramic and plastic.
KUC50 KUC50.2
2 2
1 1
/ 1
KUC50.91
/
/
1