pro user NFC2200 Manual De Instrucciones página 7

Display mode button sets and shows one of the following readings:
LED Indicators
On the front panel there are also 4 LED indicators for the following function:
REVERSE – Reverse Polarity. The DC Clamps have been connected at the wrong pole on the
battery. Simply disconnect and reconnect the DC clamps at the correct pole, restart the
charging process.
FAULT – Battery Fault. When this is light, this mean the battery can be broken. If the battery
fault display persists after resetting the charger, the battery may be faulty. Please consult a
nearby battery service centre.
CHARGING – This shows the battery is in charging process.
FULL– This shows the battery is fully charged and the battery charger is in maintenance mode.
6. Charging
Insert the AC plug into the mains supply (220-240 Volts AC only).
The battery charger is now in the stand-by mode with the default choice of "Gel Cell/SLA"
battery selection and 2A Charging.
This is the standard charging mode and if the Start Charging Button is now pressed, the
charger will immediately go into the 2A DC, Gel Cell battery charging mode.
For alternative selection, please follow the following steps:
Step 1 – Press the Charge rate button to select the charging power (current)
Step 2 – Press the Battery type Button to select the battery type for charging.
Step 3 – Press the Start charging Button to start the charging process.
Battery Fault – A few seconds after switching on to the operating mode, the LED indicator
"FAULT" will illuminate if the following occurs:
A. Low battery voltage - < 3 V
B. High battery voltage - > 15 V (12 V battery)
C. Battery short circuit or battery cell short circuit
Under these conditions, the battery charger will stop charging. In the event of A, B or C, the
battery may be defective and we advise you to consult your nearest battery service centre.
When the LED "FULL" illuminates, the battery is completely charged. The battery charger will
now go into maintenance mode. No attention is required until the battery is required for use
again.
Output current – This shows the selected
charging current.
Battery voltage –This shows the voltage of the
battery in DC.
Charging % –This shows an estimate percent
of charge.