Cembre HT51 Manual De Uso Y Mantenimiento página 5

2.3) Crimping
– Continue to operate the moveable handle (36).
The tool will automatically change over to the high pressure stage and the ram (16) will advance
until the dies meet.
– It is recommended to continue pumping until the maximum pressure valve is activated and a
"click" is heard.
2.4) Head rotation
For ease of operation, the tool head can rotate through 180°.
Warning: do not attempt to turn the head if the hydraulic circuit is pressurised.
2.5) Die re-opening
Press the pressure release lever (44) for the rapid retraction of the ram (16) and subsequent die
re-opening, releasing the crimped connector.
2.6) Rest setting
After completion of the work, press the pressure release lever (44) to release the oil pressure in
the tool.
Fit the handle restraint (01).
The tool is robust and requires very little daily maintenance.
Compliance with the following points should help to maintain the optimum performance of the tool.
3.1) Accurate cleaning
Dust, sand and dirt are a danger for any hydraulic
device.
Every day, after use, the tool must be wiped with
a clean cloth, taking care to remove any residue,
especially close to pivots and moveable parts.
3.2) Storage
When not use, the tool should be stored and trans-
ported in the plastic case, to prevent damage.
Plastic case: VAL-P1; Size: 445x290x95 mm
(17.5x11.4x3.7 in.); weight: 1,2 kg (2.65 lbs).
The case can also hold up to 20 die sets.
5
3. WARNING