i.safe MOBILE IS930.M1 Manual Del Usuario página 5

FAULTS AND DAMAGES
If there is any reason to suspect that the safety of the device has been compromised, it must
be withdrawn from use and removed from any ex-hazardous areas immediately.
Measures must be taken to prevent any accidental restarting of the device.
The safety of the device may be compromised, if for example:
Malfunctions occur.
The housing of the device shows damage.
The device has been subjected to excessive loads.
The device has been stored improperly.
Markings or labels on the device are illegible.
We recommend that a device displaying errors or in which an error is suspected be sent back
to i.safe MOBILE GmbH to be checked.
EX-RELEVANT SAFETY REGULATIONS
Use of this device assumes that the operator observes the conventional safety regulations and
has read and understood manual, safety instructions and certificate.
The following safety regulations must also be complied with:
Inside ex-hazardous areas the covers of all interfaces must be closed.
To ensure the IP-protection, it has to be ensured that the all gaskets are present and functional.
There must be no large gap between the two halves of the housing.
The device may only be charged outside ex-hazardous areas using the i.safe PROTECTOR 2.0
or i.safe PROTECTOR 3.0 USB-cable or other equipment approved by i.safe MOBILE GmbH.
The device may only be used in Zone M1 or M2.
The device may be charged only at ambient temperatures in between +5°C ... +35°C.
The device may not be exposed to any aggressive acids or alkalis.
The device shall be protected from the exposure of oils, greases and hydraulic fluids
The device must be protected from impacts with high impact energy, against excessive
UV light emission and high electrostatic processes.
Accessories like SD card type IS-SD164.1 and IS-SD1128.1 may be used.
FURTHER SAFETY ADVISES
Do not touch the screen of the device with sharp objects. Dust particles and nails may scratch
the screen. Please maintain the screen clean. Remove dust on the screen with a soft cloth
gently, and do not scratch the screen.
Do not put the device in environments with excessive temperatures, as this could lead to
heating of the battery, resulting in fire or explosion.
Do not charge the device near any flammable or explosive substances.
Charge the device under dry indoor conditions only.
Do not charge the device in environments with much dust or humidity.
Do not use the device in areas where regulations or legislatives prohibit the use.
Do not expose the device or charger to strong magnetic fields, such as are emitted from
induction ovens or micro-waves.
Do not attempt to open or repair the device. Improper repair or opening can lead to the
EN 5