Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
Assembly
Fitting the accessories (fig. A & B)
This model is supplied with the following
accessories:
A crevice tool (8) for confined
spaces.
A brush tool (9) for furniture and
stairs.
To fit an accessory, proceed as follows:
Take the accessories from its
storage position on the appliance or
charging base (7) (fig. L & M).
Insert the appropriate accessory into
the front of the appliance.
Residual risks
Additional residual risks may arise when
using the tool which may not be included
in the enclosed safety warnings. These
risks can arise from misuse, prolonged
use etc.
Even with the application of the relevant
safety regulations and the
implementation of safety devices, certain
residual risks cannot be avoided. These
include:
Injuries caused by touching any
rotating/moving parts.
Injuries caused when changing any
parts, blades or accessories.
Injuries caused by prolonged use of
a tool. When using any tool for
prolonged periods make sure you
take regular breaks.
Impairment of hearing.
Health hazards caused by breathing
dust developed when using your tool
(example:- working with wood,
especially oak, beech and MDF).
Use
Before first use, the battery must be
fully charged.
Place the appliance on the charging
base whenever it is not in use.
Charging the battery (fig. C)
Before charging the battery:
8
Make sure that the dust collector
extension (1) is pushed back into the
dust collector (2).
Make sure that the appliance is
switched off. The battery will not be
charged with the on/off switch (4) in
the on position.
Place the appliance on the charging
base (7) as shown.
Plug in the charger. Switch on at the
mains.
While charging, the charger may become
warm. This is normal and does not
indicate a problem. The appliance can be
left connected to the charger indefinitely.
The charger on this unit has been
designed to save energy but also give
faster charging. When the unit is in the
fast charge mode the charge indicator (5)
will be illuminated most of the time with
short off periods. When the charger
detects that full charge has been reached
the charger will change modes and the
indicator will be off most of the time with
short pulses on showing that the charger
is maintaining the battery charge and
keeping the product ready for use. The
charge time to recharge a fully
discharged battery will be about 5 hours.
Adjusting the dust collector (fig. D)
Extend the dust collector (2) by
pulling the dust collector extension
(1) until it locks into position.
Retract the dust collector extension
(1) by pressing the area (12) marked
with an arrow and pushing the dust
collector extension (1) back into the
dust collector (2).
Switching on and off (fig. E)
To switch the appliance on, slide the
on/off switch (4) forward.
To switch the appliance off, slide the
on/off switch (4) back.
Optimising the suction force (fig. F)
In order to keep the suction force
optimised, the filters must be cleared
regularly during use.
Publicidad
Tabla de contenido
