Care And Maintenance; Cleaning The Filters; Leaving The Machine Unused For Extended Periods - Hotpoint Ariston LI 480 A Manual De Instrucciones

Ocultar thumbs Ver también para LI 480 A:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 61

Care and maintenance

Cleaning the filters

The filters remove food residue from the water used
in the wash cycle: to obtain the best results from
each wash, they should be cleaned.
Clean the filters regularly.
After cleaning check that the filter assembly has
been replaced correctly.
The dishwasher should not be used without
filters or when the filter is loose..
1. Remove the filters by pulling the handle upwards.
2. Clean the filters:
running water.
clockwise direction). Use a small non-metallic brush
to clean these parts.
3. Reconstruct the filter assembly and replace it in
the correct position, following movements 1 and 2 as
shown in the figure, until it clicks into place.
Leaving the machine unused for
extended periods
• Disconnect the appliance from the electricity
supply and shut off the water tap.
• Leave the door of the appliance ajar.
• When you return, run a wash cycle when the
dishwasher is empty.
• after every wash
cycle, remove the
largest pieces of
residue from
semicircular plate A
and glass B (these
may be removed by
pulling the handle) by
rinsing them under
• The entire filter
assembly should be
cleaned thoroughly
once a month: this
includes the
semicircular plate A,
the glass B and the
cylinder C (this may
be removed by
turning it in an anti-

EN

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Li 485 a

Tabla de contenido