Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Brown is for Live (L) (2) and Blue is for Neutral (N)
(4).
• Before replacing the top cover of the mains plug
ensure that the cable restraint (3) is holding the
outer sheath of the cable firmly and that the two
leads are correctly fixed at the terminal screws.
Never use a light socket.
Never connect the live (L) or neutral (N)
wires to the earth pin marked E or
For 115 V units with a power rating exceeding 1500
W, we recommend to fit a plug to BS4343 standard.
Using an extension cable
If an extension cable is required, use an approved
extension cable suitable for the power input of this
tool (see technical data). The minimum conductor
2
size is 1.5 mm
.
When using a cable reel, always unwind the cable
completely.
Also refer to the table below.
Conductor size (mm
2
)
0.75
1.00
1.50
2.50
4.00
Voltage
Amperes
115
0 - 2.0
2.1 - 3.4
3.5 - 5.0
5.1 - 7.0
7.1 - 12.0
12.1 - 20.0
230
0 - 2.0
2.1 - 3.4
Cable rating (Amperes)
6
10
15
20
25
Cable length (m)
7.5
15
25
30
45
Cable rating (Amperes)
6
6
6
6
6
6
6
6
15
6
6
10
15
20
10
10
15
20
20
15
15
20
25
25
20
20
25
-
6
6
6
6
6
6
6
6
3.5 - 5.0
5.1 - 7.0
7.1 - 12.0
12.1 - 20.0
Assembly and adjustment
Inserting and removing 19 mm hex. accessories
(fig. B1 & B2)
This machine uses chisels with a 19 mm hex. shank
(refer to the inset in fig. B2 for a cross-section of a
chisel shank).
We recommend to use professional accessories only.
• Clean and grease the chisel shank.
.
• Pull back the locking sleeve (6), align the groove
(8) with the yellow marker (7) and insert the chisel
shank into the tool holder (5). Release the locking
sleeve.
• Pull on the chisel to check if it is properly locked.
The hammering function requires the chisel to be
able to move axially several centimetres when
locked in the tool holder.
• To remove a chisel pull back the tool holder
locking sleeve (6) and pull the chisel out of the
tool holder.
Indexing the chisel position (fig. C)
The chisel can be indexed and locked into 12 different
positions.
• Insert the chisel as described above.
• Rotate the collar (4) in the direction of the arrow
until the chisel is in the desired position.
60
Fitting and adjusting the side handle (fig. D)
6
10
The side handle (3) can be mounted on the front of
15
the machine to suit both RH- and LH-users.
20
25
-
-
-
6
6
6
6
6
6
10
10
10
15
15
15
20
20
20
Prior to assembly and adjustment always
unplug the tool.
Do not apply lubricant to the machine.
Always operate the machine with the
side handle properly mounted.
E N G L I S H
6
6
10
15
10
15
15
15
20
20
20
25
-
23
Publicidad
Tabla de contenido
