Kalorik USK TO 20621 Manual De Instrucciones página 5

Fax +32 2 359 95 50
CAUTION: the bread carriage handle will not stay down if the
appliance is not plugged in!
BEFORE USING THE TOASTER FOR THE FIRST TIME
In order to eliminate any manufacturing residues, operate the toaster
a couple of times without bread with the browning control selector
on a medium power level. Some smoke might escape.
OPERATION
Before using your appliance for the first time, check if it is clean
•
(see "Maintenance and cleaning") as it comes into direct
contact with bread. Check if any object has fallen into the slot.
Connect the appliance only to a mains earthed wall socket. A
•
grommet on the bottom of the appliance enables to maintain
the cord by positioning it to the backside of the appliance.
Place the bread slices in the slot (for the French bread, cut a loaf
•
shorter than the slot, then cut it in two pieces along its length.).
Your appliance is provided to receive French bread, but also
pieces of toast or other bread slices if their thickness and their
length are shorter than the one of the slot.
Press down the bread carriage handle until it stops (in the same
•
time, the grid inside the slot will tighten around the bread in order
to keep it away from the heating wires). Then release the pressure
and the handle will stay in the lower position, which means that
the heating process has begun. If the handle comes up
immediately, check if the appliance is plugged in as it blocks
when the unit is plugged in.
You can adjust the browning intensity to obtain a more or less
•
toasted bread by positioning the browning control selector to
one of the degrees marked from 1 to 7. Therefore you only have
to turn clockwise to increase the intensity, and anticlockwise to
decrease it. The higher the number is, the more toasted the
bread will be.
During the functioning, if you think that the bread is toasted
•
enough or for another reason, you can break the heating
process, simply by pressing the CANCEL button.
Copies of the I/B. Please reproduce them without any
changes except under
International BELGIUM. The pages must be reproduced and
folded in order to obtain a booklet A5 (+/- 148.5 mm width x
210 mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't change
the page numbering. Keep the language integrity.
what is inside the frame.
5
Assembly page 5/24
special instruction from Team
Print only
USK TO 20621 / TO 32763 - 110127