BeeWi BBZ352 Manual Del Usuario página 6

All manuals and user guides at all-guides.com
6
2.2. BeeWi HeliPad Installation
Go to iTunes and look for "BeeWi-HeliPad" app. Fol-
low the on-screen indications to download and install
the app. Once the application has been successfully
installed, you can launch it directly. Insure the Helicop-
ter has been paired and connected prior to start the
application.
2.3. Pairing
To pair the Helicopter with your device, refer to the pairing procedures in your mobile
phone user manual and follow the instructions below:
- Power on the Helicopter to turn the unit in pairing mode (wait 30 seconds)
- In the iPhone Bluetooth menu, search for devices, select the device name "BeeWi BBZ352"
to pair and connect it. When prompted, enter the pass key "0000".
3. USING THE HELICOPTER
3.1. Connection
If it has been previously paired, the Helicopter will automatically connect to the iPhone
when it is powered on. If this is not the case, you can also go to the iPhone Bluetooth menu
and select the "BeeWi BBZ352" device in your device list. Once the status is "Connected",
close the Bluetooth menu and get back to the main screen.
If you are using 2 different helicopters with the same device, always make sure there is
only one connected at a time or the application will malfunction.
3.2. User Interface
Upon connection, the BeeWi HeliPad application will open automatically. If it is not the
case, you can always launch it from the phone app screen.
ENGLISH