Step 3. Install The Anti-Tip Device - Samsung NX60 8 Serie Manual De Instalación

Installation instructions
3. Install male 0.5-in (1.3-mm) or 0.75-in (1.9-mm) flare union adapter to the NPT
internal thread of the manual shut-off valve, taking care to back up the shut-off
valve to keep it from turning.
4. Connect flexible metal appliance connector to the adapter on the range. Position
range to permit connection at the shut-off valve.
5. When all connections have been made, make sure all range controls are in the
off position and turn on the main gas supply valve. Use a liquid leak detector at
all joints and connections to check for leaks in the system.
WARNING
To prevent death, personal injury, explosion, and/or fire hazard, DO NOT use a
flame to check for gas leaks.
When using test pressures greater than ½ psig to pressure-test the gas supply
system of the residence, disconnect the range and individual shut-off valve from
the gas supply piping. When using test pressures of ½ psig or less to test the gas
supply system, simply isolate the range from the gas supply system by closing the
individual shut-off valve.
WARNING
Do not exceed 25 ft-lbs of torque when making gas line connections.
Overtightening may crack the pressure regulator resulting in a gas leak.
Flexible connector hookup
Installer: Inform the consumer of the location of the gas shut-off valve.
Gas Shut-Off Valve
0.5-in or 0.75-in
Gas Pipe
Tubing Line to
Oven Burner
Adapter
Control Valve
Tubing Line
Flex
to Cooktop
Connector
Control
(6-ft max.)
Manifold
Pressure
Adapter
Regulator
20 English
Install_NX60T8755SS_AP_DG68-01326A-01_MES+EN.indb 20 Install_NX60T8755SS_AP_DG68-01326A-01_MES+EN.indb 20
NOTE
If your area requires a rigid pipe hookup,
contact a qualified installer, service agency,
or gas supplier.
NOTE
The gas shut-off valve should be installed
in an accessible location in the gas piping,
external to the appliance, for the purpose
of turning on or shutting off the gas to the
appliance.

Step 3. Install the anti-tip device

WARNING
To reduce the risk of tipping, the appliance must be secured by properly installing
the anti-tip device packed with the appliance.
• All ranges can tip, resulting in personal injury.
• Tipping ranges can cause burns from spills, personal injury, and/or death.
• To prevent accidental tipping, install and check the anti-tip bracket following the
instructions and template supplied with the bracket.
Anti-Tip
bracket
*approximately
/ " (16.5 mm)
21
32
Screw must enter
wood or concrete
To check if the bracket is installed and engaged properly, remove storage drawer
and look underneath the range to see that the leveling leg is engaged in the
bracket. Carefully tip the range forward. The bracket should stop the range within
4 inches (10.2 cm) of tipping. If it does not, the bracket must be reinstalled.
An anti-tip bracket and screws, installation
instructions, and template are shipped
with every range (PN DG94-00870B). The
instructions include information necessary
to complete the installation of the anti-tip
bracket. Read and follow the instructions on
the sheet and use the template for anti-tip
bracket installation. If not properly installed,
the range could be tipped by you or a child
standing, sitting, or leaning on an open oven
door.
*NOTE: To install the Anti-Tip
bracket, release the leveling
leg. A minimum clearance of
21 / " (16.5 mm) is required
32
between the range bottom
and the kitchen floor.
2021-02-19 오후 6:49:27 2021-02-19 오후 6:49:27