Wi-Fi Protected Setup - Cisco Linksys X2000 Manual Del Usuario

Linksys X2000/X3000
Wireless-N Only If you have only Wireless-N devices, select Wireless-N
•
Only .
Disabled
• If you have no Wireless-B, Wireless-G, and Wireless-N devices in
your network, select Disabled .
NOTE
If you are not sure which mode to use, keep the default, Mixed .
Network Name (SSID) The Service Set Identifier (SSID) is the network name
shared by all devices in a wireless network . It is case-sensitive and must not
exceed 32 keyboard characters . The default is Cisco followed by the last 5 digits
of the router's serial number, which is found on the bottom of the router . If
you used the setup software for installation, then the default Network Name is
changed to an easy-to-remember name .
NOTE
If you restore the router's factory default settings (by pressing the
Reset button or using the Administration > Factory Defaults screen),
the Network Name will return to its default value, and all devices
on your wireless network will need to be reconnected .
Channel Width
For best performance in a network using Wireless-B, Wireless-G
and Wireless-N devices, select Auto (20 MHz or 40 MHz) . For a channel width
of 20 MHz, keep the default, 20 MHz only .
Channel
Select the channel from the drop-down list for Wireless-B, Wireless-G,
and Wireless-N networking . If you are not sure which channel to select, then
keep the default, Auto .
SSID Broadcast When wireless clients survey the local area for wireless
networks to associate with, they will detect the SSID broadcast by the router .
To broadcast the router's SSID, keep the default, Enabled . If you do not want to
broadcast the router's SSID, then select Disabled .

Wi-Fi Protected Setup

Three methods of Wi-Fi Protected Setup are available . Use the method that
applies to the client device you are configuring .
NOTE
Wi-Fi Protected Setup configures one client device at a time .
Repeat the instructions for each client device that supports Wi-Fi
Protected Setup .
Wi-Fi Protected Setup light activity
• The Cisco logo on the top panel of the router functions as the Wi-Fi
Protected Setup light .
• When the Wi-Fi Protected Setup process is active, the light flashes slowly .
When the Wi-Fi Protected Setup is successful, the light is continuously lit .
If there is an error, the light flashes quickly for two minutes; please wait
•
and try again .
Wait until the light is continuously lit, before starting the next Wi-Fi
•
Protected Setup session .
Advanced Configuration
16