Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
3. Pull spool (D) from drum (A), and pull drum (A) off mounting shaft.
4. Use one piece of new nylon line (E) 6 m (20 ft.) long and thread through the
molded loop (F) on the spool. Pull line tight and adjust so one end is 15 cm
(6 in.) longer than the other.
5. Hold the spool, pegs toward you. Place index finger between the two
strands, and wind line tightly and evenly in the direction of arrow. Avoid
twisting lines.
6. Place ends of lines into notches (G) in spool (D), leaving 6 in. protruding.
7. Place spool (D) over drum (A), Feed ends of line outward through eyelets
(H) in drum.
8. Hold spool and drum securely with one hand, and pull each line to disengage
from notches.
9. Slide drum and spool onto mounting shaft.
NYLON LINE HEAD INSTRUCTIONS
A
D
C
B
G
G
D
D
H
H
A
D
A
3
E
F
Publicidad
Tabla de contenido
