Publicidad
Idiomas disponibles
Idiomas disponibles
In case of a minor paper jam:
Place the switch in the REV and pull the remaining sheets of paper out of
the feed opening. Remove the excess portion of paper from the top and
clear any excess paper shreds from the feed opening. When the excess
paper has been removed, place the switch back into the AUTO position.
In case of a major paper jam:
1. Turn off or unplug the power cord from the AC outlet and wait at least
30 minutes for the thernal overload protection to reset.
2. Plug in the AC power cord and place the switch back into the AUTO
position. If paper was left inside the feed opening prior to the
overload, place the switch in REV and grasp the excess paper from the
top and pull it out. Be careful not to place your fingers near the feed
opening or serious harm could occur.
3. Place the switch back into the AUTO position. You are now ready to
resume normal shredding.
Important - Please read these instructions fully before installation
BEFORE USE
• Dispose of all packaging carefully and responsibly.
• This appliance is designed for indoor use only. Do not use outdoors.
• Do not use this shredder for industrial and commercial use, or any
other purpose.
• The shredder MUST be positioned on a firm level base before and
during use.
• Ensure the power cable is not caught under the appliance.Des
• Ensure the correct power supply is used (230V AC).
• Keep power cord away from hot surfaces.
• Do not place the shredder near a heat source or in direct sunlight.
SAFETY INFORMATION
8
Publicidad
