cecotec Conga Rockstar 500 Ultimate Manual De Instrucciones página 19

ENGLISH
To install the suction base into the vacuuming tube, align both of them making sure the tab on
the suction base matches the guides on the tube, and introduce one into the other until they
are firmly fixed. To disassemble them, press the suction base release button and pull from the
vacuuming tube while you hold the suction base.
Note: when assembling these 2 parts, make sure the handle and the brush are facing the same
direction.
Battery and handheld vacuum cleaner assembly
1. Introduce the battery in the slot located in the handheld vacuum cleaner. Once it is
introduced, move it slightly to ensure it is properly assembled in place.
Fig. 3
2. Following the below illustration, keep the vacuuming tube vertically, align the tab on the
vacuuming tube with the guides in the handheld vacuum cleaner and introduce the tube.
Dust tank and handheld vacuum cleaner
To assemble the dust tank to the handheld vacuum cleaner, first separate the handheld
vacuum cleaner from the vacuuming tube.
Then, press the vacuuming tube release button with one hand and, holding from the handle
with the other one, turn the dust tank anticlockwise to the unlock position indicated on the
dust tank edge.
To disassemble the dust tank, turn it clockwise until it reaches the unlock position.
Fig. 4
Suction base, vacuuming tube and handheld vacuum cleaner installation
To complete the full installation of the device, hold the vacuuming tube with the suction base
assembled upright and introduce the tube in the handheld vacuum cleaner as shown on the
illustration.
Fig. 5
4. OPERATION
Handheld vacuum cleaner
Once the handheld vacuum cleaner has been disassembled from the vacuuming:
Press the On/off button to turn the device on.
Press the power push button to select the desired power level.
It will automatically operate in Eco mode. The power level can be adjusted at any moment by
pressing this button.
Press once to switch to Daily mode.
Press again to operate it at Turbo mode.
Press the On/off button to turn the device off.
36
CONGA ROCKSTAR 500 ULTIMATE
Fig. 6
Upright Vacuum Cleaner
Press the On/off button to turn the device on.
Press the power push button to select the desired power level.
It will automatically operate in Eco mode. The power level can be adjusted at any moment by
pressing this button.
Press once to switch to Daily mode.
Press again to operate it at Turbo mode.
Press the On/off button to turn the device off.
Accessories
This device includes different accessories that allow cleaning different types of surfaces,
objects and dirt. Some of them are suitable for the upright vacuum cleaner, and others are
preferably used with the handheld one.
Jalisco brush
Assemble this brush to the upright vacuum cleaner. This brush is designed especially for
cleaning hard floors, but can be used to clean efficiently soft floors too. The brush counts
on a protection system that avoids tangles and prevents the device from being damaged. As
the brush stops rotating and the device stops operating automatically when it vacuums big
objects or excessive dirt.
Fig. 7
Silicone and bristles brush
Interchangeable brush made of silicone and bristles, ideal for cleaning carpets and pet hair.
This accessory is used with the upright vacuum cleaner.
2-in-1 wide brush for furniture and corners
This accessory is used with the handheld vacuum cleaner and allows cleaning furniture
without damaging it and reaching less accessible dirt in corners.
2-in-1 narrow brush for furniture and corners
This accessory is used with the handheld vacuum cleaner and allows cleaning furniture
without damaging it and reaching less accessible dirt in corners.
Fig. 8
Wall bracket
This product includes a wall bracket that allows hanging the vacuum cleaner from the wall.
The same bracket has different accessory holders that allow storing accessories while not in
use.
ENGLISH
37
CONGA ROCKSTAR 500 ULTIMATE