Installation Instructions - ELICA EBS51SS1 Manual Del Usuario

Before Using Your Appliance

Remove the exterior and interior packing.

Before connecting the appliance to the power source, let it stand upright for approximately 2 hours. This will reduce
the possibility of a malfunction in the cooling system from handling during transportation.

Clean the interior surface with lukewarm water using a soft cloth.

Install the handle on the left side of the door using the screws that are provided.
Avoid use of abrasive products and never use alcohol!
Installation of Your Appliance

This appliance is designed for free standing or built-in (fully recessed) installation.

Place your appliance on a floor that is strong enough to support it when it is fully loaded. To level your appliance,
adjust the front leveling legs at the bottom.

Locate the appliance away from direct sunlight and sources of heat (stove, heater, radiator, etc.). Direct sunlight
may affect the acrylic coating and heat sources may increase electrical consumption. Extremely cold ambient
temperatures may also cause the unit not to perform properly.

Avoid locating the unit in moist areas.

Plug the appliance into an exclusive, properly installed and grounded wall outlet. Do not under any circumstances
cut or remove the third (ground) prong from the power cord. Any questions concerning power and/or grounding
should be directed toward a certified and authorized products service center.

This appliance is intended to be installed in a space between two units.
The minimum space required is:
600mm wide × 600mm deep × 865mm high
Please note: When the product is installed, there should be a small ventilation gap between the top of the unit and
the underside of any fitting above (6mm or 1/4").

The appliance should always be plugged into its own individual electrical outlet which has a voltage rating that
matches the rating label on the appliance. This provides the best performance and also prevents overloading
house wiring circuits that could cause a fire hazard from overheating. Never unplug the appliance by pulling on the
power cord. Always grip the plug firmly and pull straight out from the receptacle. Repair or replace immediately all
power cords that have become frayed or otherwise damaged. Do not use a cord that shows cracks or abrasion
damage along its length or at either end. When moving the appliance, be careful not to damage the power cord.
Installation of the Handle
To install the handle, please follow these instructions:

Carefully pull the door gasket (seal) away from the door in the area where the handle will be attached.

Place the handle over the screw holes on the outside of the door and attach it with the screws that have been
provided. Tighten the screws.

Press the door gasket back into its groove.
- SAVE THESE INSTRUCTIONS -

INSTALLATION INSTRUCTIONS

6