ELICA EBS51SS1 Manual Del Usuario página 7

How to put off the shelves
1. Remove all bottles from the shelve.
2. Please keep the door opened fully all the way before pulling the shelves out.
3. Pull the shelf forwards(seeing ①) until groove on either side of the shelf is level with plastic peg on either side of
the cabinet(seeing ②). Then lift the shelf up from one side(seeing ③), and pull forwards(seeing ④).
Reversing the Door Swing
This appliance has the capability of the door opening from either the left or right side. The unit is delivered to you with
the door opening from the left side. Should you desire to reverse the opening direction, please follow the instructions
below.
To make the reversal, you will find two hardware pieces in a plastic bag inside the appliance: the top left door hinge
and left bottom door hinge core assembly.
Carefully lay the appliance on its back. Use cushioning to protect the floor and appliance.
1.
Using a Slotted screwdriver to remove the upper door hinge core at the upper right corner of the door.
2.
Using a Philips screwdriver, remove the two screws of bottom right hinge core beneath the door. Keep the hinge
3.
in a safe place in case you need to reverse the door again in the future.
Carefully slide the door off and place it on a padded surface.
4.
Using a Philips screwdriver, remove the screws from the top right hinge, remove the top right hinge and keep it
5.
in a safe place in case you want to reverse the door in the future.
Remove the screws from the top left and transfer to the right.
6.
Install the top left hinge.
7.
Rotate the door 180° and take out the bottom left door hinge core from Accessory bag, insert it to the door shaft
8.
hole in the lower left corner of the door .
Put the door back into the cabinet, and use a Slotted screwdriver to install the door hinge core back to the door
9.
shaft hole in the upper left corner of the door body.
10. Adjust door alignment. When set, tighten screw on hinge.
7