Korona 82001 Manual De Instrucciones página 28

INSTALLATION
INSTALLATION OF THE WINDOW KIT (sliding window)
- Take the window kit and pull the inner part outside until the hole in the outer part is visible.
- Put the T-bolt from the screw set through the hole
- Push the parts of the window slide set back together, making sure the T-part of the T-bolt
slides into the slit of the inner part of the windowslide set lengthwise.
Screw the butterfly nut from the screw set loosely onto the T-bolt.
The window kit can be installed horizontally or vertically.
- Slide the window half open, and place the window kit in the frame.
- Extend the window slide set so the full width of the frame is being covered.
- Fasten the butterfly nut to fix the window slide set.
For all other types of windows, use the included window sail, instructions of use
are included.
Installation instruction for Window sail
The window sail is fixed by velcro tape to the window frame and window case. The exhaust
hose can then easily be fixed to the sail to ensure the hot air is channeled to the outside.
1. unpack the window sail and remove all Velcro tape from packing.
2. Open the window and clean the area where you like to attach the Velcro tape to from dust,
grease.
3. Double check your selected position of Velcro tape still enables you to open and close the
window properly
4. Attach the Velcro tape to the window frame and the window case.
5. Attach the window sail to the Velcro tape accordingly.
6. Open the zipper to insert the exhaust hose. Make sure it is properly fixed.
Your window sail is now ready to use.
28