Publicidad
Idiomas disponibles
Idiomas disponibles
EN GLI SH
To reverse the rotary hammer, turn it off and align
the reversing lever (h) with the yellow arrow pointing
backward (viewed when holding drill in operating
position).
To position the lever for forward operation, turn the
rotary hammer off and align the reversing lever (h)
with the yellow arrow pointing forward (viewed when
holding drill in operating position).
Mode Selector (fi g. 1, 2)
NOTICE: Tool must come to a
complete stop before activating the
mode selector button or damage to the
tool may result.
1. To select the operating mode, press mode
selector button (f) and turn the mode selector (g)
so the yellow arrow points to the corresponding
symbol.
2. Release the mode selector button and check
that the mode selector switch is locked in place.
NOTE: The yellow arrow on the mode selector
MUST be aligned with one of the symbols at all
times. There are no operable positions between the
positions.
ROTARY DRILLING MODE
Use rotary drilling mode for wood, metal,
and plastics.
HAMMERDRILL MODE
Use this mode for masonry drilling.
HAMMER-ONLY MODE
For light chiseling.
Inserting and Removing SDS Plus
Accessories (fig. 1)
WARNING: Always wear gloves when
you change accessories. The exposed
metal parts on the tool and accessory
may become extremly hot during
operation.
WARNING: Do not attempt to tighten
or loosen drill bits (or any other
accessory) by gripping the front part
of the chuck and turning the tool on.
Damage to the chuck and personal
injury may occur.
This tool uses SDS Plus
accessories We
®
recommend to use professional accessories only.
To insert bit, insert shank of bit about 19 mm (3/4")
into chuck. Push and rotate bit until it locks in place.
The bit will be securely held.
30
To release bit, pull the chuck sleeve (e) back and
remove the bit.
SDS Plus
Chuck (fi g. 1)
®
WARNING: To reduce the risk
of serious personal injury, turn
tool off and disconnect tool from
power source before making any
adjustments or removing/installing
attachments or accessories.
WARNING: Burn Hazard. ALWAYS
wear gloves when changing bits.
Accessible metal parts on the tool
and bits may get extremely hot during
operation. Small bits of broken material
may damage bare hands.
WARNING: Do not attempt to tighten
or loosen drill bits (or any other
accessory) by gripping the front part
of the chuck and turning the tool on.
Damage to the chuck and personal
injury may occur.
To insert bit, insert shank of bit about 19 mm (3/4")
into chuck. Push and rotate bit until it locks in place.
The bit will be securely held.
To release bit, pull the chuck sleeve (e) back and
remove the bit.
Fitting a Chuck Adapter and Chuck
(Sold Separately)
1. Screw a chuck onto the threaded end of the
chuck adapter.
2. Insert the connected chuck and adapter in the
tool as though it were a standard SDS Plus
®
3. To remove the chuck, proceed as for removing
a standard SDS Plus
WARNING: Never use standard chucks
in the hammer drilling mode.
Consult your dealer for further information on the
appropriate accessories.
OPERATION
Instructions for Use
WARNING: Always observe the safety
instructions and applicable regulations.
Trigger Switch (fi g. 1)
To start the rotary hammer, depress the trigger
switch (a). To stop rotary hammer, release the
switch.
bit.
®
bit.
®
Publicidad
