Publicidad
Idiomas disponibles
Idiomas disponibles
3. Place a record on the turntable platter and set the player speed to match the record speed.
Note: When playing a single (a 45 rpm record) and/or records with large centre holes, use the 45 rpm adaptor.
4. Remove the needle cartridge protective cover and unlock the tone arm from the tone arm rest.
5. Push the lift lever backward. The tone arm will gently rise up.
6. Gently move the tone arm to the desired position on the record. If the auto stop function is on, the turntable
platter will start to rotate.
7. Release the tone arm onto the turntable by pushing the lift lever forward, the tone arm will move towards the
record and the music will start to play.
If the auto stop control switch is turned ON, the record will stop automatically when finished. If auto stop control
switch is turned OFF, the record will NOT stop automatically when finished; you then must push the lift lever
backward to raise the tone arm and place it back in the rest. Then turn off the power to stop the turntable from
spinning.
Please note: The auto stop function applies to most 33RPM vinyl records. However, for very few vinyl records, it will
stop before it reaches the end or it will not stop when it has come to the end of the record.
3. RCA connection
Connect the RCA Output Jack to the external speaker system (Line in) with the RCA cable (not provided) to enjoy
vinyl records music on your speaker system.
4. Headphone Socket
On the function panel you'll find a headphone socket.
Here you can plug in your headphone with 3.5mm jack. When the headphone is connected the built-in speaker will
be switched off.
5. HOW TO REPLACE THE NEEDLE
To replace the needle, please refer to the instructions below.
Removing the needle from the cartridge
1. Place a screwdriver at the tip of the needle headshell and push downwards in the direction shown in sketch "A"
2. Remove the needle headshell by pulling it forwards and pushing downwards.
Inserting the needle
1. Hold the tip of the needle headshell And insert it by pressing in the direction illustrated by "B".
2. Push the needle headshell upwards in the direction illustrated by "C" until the needle locks into the tip position.
6
Publicidad
