Operating Controls - Sharp EL-2901RH Manual De Manejo

OPERATING CONTROLS

ON
OFF • P P•IC
POWER SWITCH; PRINT / ITEM
COUNT MODE SELECTOR:
"OFF": Power OFF
"•": Power ON. Set to the non print mode.
"P": Power ON. Set to the print mode.
"P•IC": Power ON. Set to the print and item count
mode.
For addition or subtraction, each time
pressed, 1 is added to the item counter, and
each time is pressed, 1 is subtracted.
• The count is printed when the calculated
result is obtained.
• Pressing of
counter.
Note: The counter has a maximum capacity of 3
digits (up to ±999). If the count exceeds the
maximum, the counter will recount from zero.
ROUNDING SELECTOR:
Example: Set Decimal Selector to 2.
4 ÷ 9 = 0.444 ... , 5 ÷ 9 = 0.555 ...
is
, clears the
4 9
0.45
5/4 0.44
0.44
Note: The decimal point floats during successive
calculation by the use of
If the decimal selector is set to "F" then the answer
is always rounded down ( ).
RATE
GRAND TOTAL / RATE SETTING MODE
GT •
SET
SELECTOR:
"GT": Grand Total
"•": Neutral
"RATE SET": Rate setting
• Enter the adding tax rate, then press
• A maximum of 4 digits can be stored (decimal point
is not counted as a digit).
• Only one rate can be stored. If you enter a new
rate, the previous rate will be cleared.
F 6 3 2 1 0 A
DECIMAL / ADD MODE SELECTOR:
"6 3 2 1 0": Presets the number of decimal places
in the answer.
"F": The answer is displayed in the floating decimal
system.
3
5 9
0.56
0.56
0.55
or .
.