Cleaning And Maintenance; Wet Accessory For Scrubbing - cecotec CONGA ROCKSTAR 900 ULTIMATE ERGOWET Manual De Instrucciones

ENGLISH
Motorised brush for upholstery.
Removes dust mites and bacteria from beds and sofas.
Fig. 17
Union elbow
Suitable for cleaning dust from high wardrobes, roofs, windows, corners, etc.
Fig. 18
Special brush for fabrics
Adjustable accessory to remove all types of dust trapped in fabrics.
Installation of accessories
Fig. 19
Fig. 19.1

5. CLEANING AND MAINTENANCE

Disconnect the appliance from the power supply and allow it to cool down before cleaning.
Use a soft, damp cloth to clean the device's surface.
Do not immerse the appliance in water or other liquid.
Do not use abrasive cleaners or scouring pads to clean the product.
It is recommended to clean the dust tank after every use. If the device clogs due to built-up
excessive dust, clean it or replace it.
After the brush has been used for a long time, bristles might start to tangle with hair and
other particles. Clean it in order for it to operate correctly again.
Cleaning the dust tank and the filters
Fig. 20
Fig. 21
Fig. 22
Open the dust tank bottom cover unlock button and empty the dust inside.
Hold the device from the handle and pull from it upward to separate de device from the dust
tank.
Turn the filter as shown on the image and disassemble the filter.
After washing and drying all the parts, assemble it back in order to use it again.
Cleaning the Jalisco brush and the Best Friend Care brush
Move the rotary brush release button with the finger toward the arrow and remove the cover
of one of the ends of the brush.
40 ROCKSTAR 900 ULTIMATE ERGOWET
Take one end of the brush out as shown on the image. After washing and drying all the parts,
assemble it back in order to use the brush again.
Fig. 23
Removing the battery
Press the battery release button and take the battery out as shown on the image. Store the
battery in a plastic bag and leave it in a dry place.
Fig. 24
Storing the device
If the robot is not going to be used for a long time, remove the battery from the product and
store it in a dry and safe place.
Dirt sensors
When the device does not detect dirt or dust, or detects very little, the screen will display a
full circle when turned on. In this case, wipe the dirt sensors with a soft, dry cloth.
Fig. 25.

6. WET ACCESSORY FOR SCRUBBING

When the vacuum cleaner is not going to be used for a long time, please remove the
water tank and empty the remaining water. Do not expose it to direct sunlight or to damp
environments.
Mop installation/removal
Removing/installing the water tank
Fig. 25
In order to install/remove the cleaning cloth you must first disassemble the water tank from
the rest of the appliance. In order to remove the water tank, use your foot to hold it against
the ground and pull upward until it unclicks from position.
Once the cloth has been installed and the water tank has been filled, to reinstall the water
tank, simply push it back together until it clicks into position.
Note: Do not use cleaning agents. Use clean and room temperature water only. Do not use
the vacuum cleaner to vacuum water.
Installing the mop cloth
Place the mop cloth on the ground with the Velcro facing upwards. Align the mop cloth with
the Velcro strips on the water tank and attach it.
Fig. 26
ENGLISH
ROCKSTAR 900 ULTIMATE ERGOWET 41